Aneeb Bond + Gypsum Plaster One Coat

Product Application Technique: The surface where product is to be applied should be thoroughly brushed with broom to be free of all loose particles & dust. Wash & clean traces of mould oil. Use Aneeb Bond + Bonding Agent. The sand cement plaster should be properly cured prior to the application of Aneeb One Coat Ultra gypsum plaster. Pre-wetting needs to be done just before application so as to achieve more spread ability & higher coverage.

For easy workability mix Ultra plaster to water (not vice versa). Mix plaster as much as required depending on working area. Single coat should not exceed 8mm in thickness; if higher thickness is required then Aneeb One Coat Gypsum plaster is to be applied in multiple coats. Painting can be started after complete drying of Aneeb One Coat Ultra gypsum plaster.

Mixing Instructions: We recommend water to plaster ratio in 1:2 proportion (1 part water and 2 parts plaster). Mixing of plaster has to be done in a clean container. Limited material to be mixed, the mixed material should be brought to use within one hour from the time material is added to water. Water used for mixing should be clean potable water. Mixing of plaster is to be done by help of a mixing rod. Thorough mixing is to be done till a consistent paste is formed. An ideal plaster paste would be a consistent paste, sticky in nature with no lumps of plaster within it, easy to carry and apply by trowel.

Storage at Sites: Gypsum being hygroscopic in nature absorbs moisture; store gypsum bags in a dry, well-ventilated area elevated at least 5 cm above ground on wooden planks, stacked no more than 10 bags high. Keep open bags tightly sealed.